Dometic RM2410 Instrukcja Użytkownika Pobierz pdf (Strona 9)

- 9 -

MOUNTING INSTRUCTIONS

CHANGING THE DOOR SWING

Open the door and remove the two screws holding

the top decoration. The screws are accessible from

beneath.

Remove the top hinge pin and lift out the top door.

Unscrew the bottom hinge pin.

Remove the plastic cap from the opposite lower

hinge and place it in the hole just “left empty” by the

lower hinge pin.

Screw the lower hinge pin in the hole from which

the plastic cap was removed.

Before replacing the door on the refrigerator, remove

the catches and move them to the opposite side of

the cabinet.

The holes are covered with plastic caps that must be

removed and inserted in the holes that previously

held the catches.

Unscrew the handle and move it to the opposite side

of the door.

Insert the plastic caps into the holes left open on the

door. (Plastic caps for empty holes are in the parts

bag inside the refrigerator.)

Remount the door and hinge pins in the reverse order

of their removal.

Before the top decoration is retted, check that the

door closes easily and the gasket seals well on all

sides.

10.

11.

REFRIGERATOR REMOVAL

To remove the refrigerator, follow these steps:

Cap the gas supply line.

Loosen the screws anchoring the refrigerator to the

enclosure.

Slide the refrigerator out of the compartment.

Replacement is the reverse of removal. When reinstalling the

refrigerator, make sure the sealing strips are properly posi-

tioned. Check all connections for gas leaks.

Before removing the refrigerator:

Verify that the AC and DC voltage leads are disconnected.

Shut off the gas supply.

Disconnect the gas supply line at the rear of the refrigerator.

Always use a back up wrench when loosening and tighten-

ing connections.

•

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Dometic RM2410 Instrukcja Użytkownika Strona 9

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Dometic RM2410