Dometic RM2410 Instrukcja Użytkownika Pobierz pdf (Strona 11)

- 11 -

RM2510

To start the refrigerator, turn the knob (A) to the

GAS position. Lamp (E) is lit.

Turn the thermostat knob (B) one quarter (1/4) of a

turn from the OFF position.

Press button (C) - and hold.

When the lamp (E) stops ashing, hold button (C) an

additional 15 seconds.

Release button (C). If the lamp (E) starts to ash

again, repeat the procedure.

If ame blows out, the reigniter will automatically

relight the ame.

To shut off the refrigerator, turn the knob (A) to OFF.

NOTE!

After changing an LP tank, or after a long shut off period, the

gas line is likely to be lled with air. You may have to repeat

the lighting procedure several times to purge the air out of the

gas lines.

ELECTRIC OPERATION

Check to be sure the power cord is properly con-

nected to the power supply.

Turn knob (A) to the position marked ELEC for

120 V AC operation.

Turn the thermostat knob (B) one quarter (1/4) of a

turn from the OFF position.

To shut off the refrigerator, turn knob (A) to OFF.

THERMOSTAT

The refrigerator is equipped with a thermostat which can be ad-

justed by turning the thermostat knob to MAX (coldest cabinet

temperature) or OFF (warmest cabinet temperature) to obtain

the desired cabinet temperature.

OFF: In gas operation, the thermostat closes its main valve

and the burner runs continuously at the bypass rate or pilot.

In electric operation, the contacts in the thermostat are open

and the heating element is off.

MAX: In gas operation, the thermostat allows the burner to

remain on high ame continuously. In electric operation, the

heating element is “ON” continuously.

When the thermostat reaches the set temperature, it will cut the

burner back to bypass or, in electric operation, shut off the heat-

ing element.

The setting of the thermostat is not critical, but we recommend

it be adjusted to maintain a dry frost on the cooling ns. When

it gets warmer outside, adjust the thermostat knob closer to

MAX.

SHUTOFF

To shut off the refrigerator, turn the knob (A) to OFF. If the

refrigerator will not be in operation for a period of weeks, you

should empty, defrost and clean it; and leave the doors ajar. Dry

the ice tray and keep it outside the cabinet.

•

OPERATING INSTRUCTIONS

RM2410

Before starting the refrigerator, check that all the manual gas

valves are in the ON position.

To start the refrigerator, turn the knob (A) to the

GAS position.

Turn the thermostat knob (B) one quarter (1/4) of a

turn from the OFF position.

Press button (C) - and hold. While holding but-

ton (C) - press button (D) several times to light the

burner. This can be observed through the ame view

port, (E).

After the ame is lit, continue to hold button (C)

for 10 seconds. Release button (C) and check the

ame view port (E) to make sure the burner does

not go out. If the burner goes out, repeat the lighting

procedure.

To shut off the refrigerator, turn the knob (A) to OFF.

FIRE HAZARD. Before lighting the gas burner,

after that the RV has not been used for some

time, please check that the gas path between

the burner jet and the burner tube has not been

obstructed. Failure to heed this warning could

cause a re resulting in personal injury

WARNING

GAS OPERATION

Pressure test port

Burner jet

Burner tube

Spark electrode

Burner mounting screw

Thermocouple

Spring

Thermocouple

connectio

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

Dometic RM2410 Instrukcja Użytkownika Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Dometic RM2410