Dometic RC1100EGP Instrukcja Użytkownika Pobierz pdf (Strona 4)

4.Installation

To be installed horizontally on a smooth, firm or any other appropriate surface. If necessary,

adjust/align using a spirit level or a water-filled vessel.

There should be a distance of at least 10cm between the back of the unit and any other object (wall).

Avoid placing unit in direct sunlight and next to other sources of heat.

For good air circulation the air vents on the top and under sides, as well as at the back of the cooling

unit must not be obstructed.

This will result in a good, energy-saving cooling system.

5.Cleaning

Prior to initial use and later after defrosting, or prior to a prolonged period out of operation, clean the

container and lid with luke-warm water and, if necessary, washing-up liquid. Warning: do not

inadvertently press or force the opened door past its stop-point (this could cause the hinges

to break). Never use scouring or corrosive agents to clean the unit. Wipe cleaned surfaces dry

with a soft cloth.

6.A/C operation

Do not use any additional form of energy (batteries/gas).

Check that the supply voltage corresponds with the line-voltage data on the type-plate (see back of

unit).

(The following instructions refer in the main to coolers manufactured for the United Kingdom).

The mains lead of your refrigerator is fitted with a non-rewirable moulded-on 13 amp plug containing

a 3 amp fuse. It is a regular earthed plug for connection to a regular earthed socket.

Due to the difference in the plugs used, an adapter will be necessary for other countries.

If the fuse requires replacing at any time, the fuse cover/carrier should be removed using a small

screwdriver to lever it out. The old fuse should be replaced by a 3 amp ASTA approved BS 1362 fuse

and the fuse cover/carrier must be refitted before the plug is used again.

If the fuse cover/carrier is lost, a replacement can be obtained from the service shops. The fuse

cover/carrier must be of the same colour as that of the coloured insert in the base of the plug. In no

circumstances must the plug be used without a correct fuse cover/carrier fitted.

If the plug supplied on the mains lead is not suitable for the socket in your home, it should be cut off

and disposed of safely, or destroyed, to avoid any possible shock hazard resulting from the plug being

inserted into a 13 amp socket elsewhere in the house. A suitable replacement plug should then be

fitted as given below.

General guide to fitting any plug

Ensure the lengths of wire inside the plug are prepared correctly. Connections should be firmly made

after all conductor strands are entered into the terminal posts. When preparing the cable ends take

care not to damage the outer sheath, or the insulation surrounding the inner conductors. Tighten all

screws. Replace the top cover of the plug and secure.

Other versions

Your refrigerator has a 3-wire mains lead which is intended for connection to a 3-pin plug and a

properly earthed socket outlet.

IMPORTANT: The wires in the mains lead of this appliance are coloured in accordance with the

following code:

1 2 3 4 5 6 7 8 9 10 11 12

Brak uwag

Dometic RC1100EGP Instrukcja Użytkownika Strona 4