Dometic RH449LDFS Instrukcja Użytkownika Pobierz pdf (Strona 7)

8.2. Interior light (fig. 6.)

Two light-emitting diodes (A) on an electronic PCB

illuminate the cooling compartment when the door is

opened.

Two sensors (B) control whether the door is open or

not and the LEDs and the door control as well will

work accordingly.

Figure 6.

8.3. Automatic Door Control LED (ADC)

(optional)

Free-standing version:

The LED (Fig. 7.A) mounted to the screw down foot

lower door hinge indicated whether the miniBar door

has been opened. If so then:

1. Open the miniBar, check the content in the

compartement and if necessary, replenish.

2. Reset the door control signal by helding the

Remote control (Fig. 8.) against the door opening

sensor and push the "red" button (Fig. 6. B).

3. Close the miniBar.

Figure 7.

Figure 8.

Built-in version:

The LED must be fitted to the door plate on the hinge

side at the upper part.

The LED can be fitted by using the components-kit

(Fig. 9).

Figure 9.

1. Fit the cable with the cable bridge (A) to the side

wall on the hinge side by drilling the holes

according to Fig. 10.

Figure 10.

2. Drill the hole for the LED according to the

Figures 11 and 12.

Figure 11.

Figure 12.

Attention!

By mounting the LED cable take care of the correct

distances otherwise the too short cable will not

allow you to open the door fully.

3. Put the LED-holder (B) into the hole from

outside.

4. Mount to insulation (C) with the LED cable and

then, snap it to the LED-holder and fit the cable

(Fig. 13).

Door front

Dorr(insid

yellow 3 °C

black

Reset

Cooling-

system

blue 5 °C

red

Reddot

Reset

Top of the miniBar

Right side wall (inside)

Door (inside)

Back of miniBar

Side Wall

Place of LED

Door front

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Dometic RH449LDFS Instrukcja Użytkownika Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Dometic RH449LDFS