Dometic VGLP Instrukcja Użytkownika Strona 2

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 2
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 1
WIRING
Wire the vacuum generator as shown in the wiring diagram. Use multistranded copper wire. Protect the wiring by
installing grommets or other protective device at holes and sharp edges. Proper fuse or circuit breaker size is
extremely important for pump and wire protection. Over-fusing this pump will result in warranty invalidation.
Dometic Corporation manufactures a complete line of sanitation products and systems. Write or call
the factory to receive free literature on the following products:
600345151 7/06
Allvoltagesofvacuumgeneratorsarewiredinthesamemanner.Routewirefrompositivesource(+)throughcorrectsize
circuit breaker or fuse to red wire at vacuum generator. Route wire from DC ground (-) to black wire at vacuum generator. (If
desired, the pre-wired connector on the vacuum generator can be cut off if necessary to complete wiring operation.)
Note: Do not over-fuse the vacuum generator. To protect the motor, use only the fuse capacities shown on chart (see reverse
side). Over-fusing will void the product warranty.
· VacuFlush
®
Toilet Systems
· SaniPottie
®
Portable Toilets
· SeaLand
®
Liquid and Dry Deodorant Products
· SeaLand
®
Environment-Friendly Holding Tank
Deodorant
· SeaLand
®
brand Toilet Tissue
· SeaLand
®
Toilet Bowl Cleaner
· SaniGard™ Holding Tank Vent Filter
· OdorSafe
®
Plus Sanitation Hose and Fittings
· TankWatch
®
Holding Tank Level Monitors
© Dometic Corporation
Reminder: For proper operation, the vacuum generator must be mounted horizontally. Make sure to connect the
dischargehosefromtheVacuFlushtoilettotheinletttingofthevacuumgenerator.
Reminder: The best system will position the vacuum generator at the same level or lower than the VacuFlush
toilet.
VACUUM TESTING
1. Prime pump with water before performing vacuum test.
2. POSITIVE PRESSURE TESTING IS NOT RECOMMENDED for J-series vacuum generators. The unit is
designed to seal with negative pressure (vacuum), and not hold positive pressure.
Przeglądanie stron 1
1 2

Komentarze do niniejszej Instrukcji

Brak uwag