Dometic Eskimo Ice 600 Instrukcja Naprawy Pobierz pdf (Strona 11)

Eskimo Ice Installation & Operation Manual INSTALLATION PROCEDURES

L-3040 ENGLISH 9

Figure 7: Seawater Piping Recommendations

Thru-Hull Inlet Fitting

A separate thru-hull fitting must be installed for each seawater pump. Do not attempt to draw water from the thru-hull fitting of an

engine, generator, or other device.

Install a scoop-type thru-hull fitting:

1. Drill a properly sized hole for the thru-hull fitting as far below the water line and as close to the keel as possible.

2. Make sure the scoop of the thru-hull fitting faces the bow.

3. Bed the scoop with marine sealant designed for underwater use, and tighten the nut onto the thru-hull to secure it.

Seacock

The seacock must be accessible and easy to close in case of emergency or to clean the strainer.

1. Install a full-flow seacock directly onto the thru-hull fitting.

2. Use Teflon tape or equivalent to seal the threads.

Seawater Piping

• Only use reinforced marine-grade hose or other suitable piping (PVC, CPVC, cupronickel, or stainless steel).

• Double clamp all hose connections.

• Use only plastic, bronze, or stainless steel fittings (do not use brass).

• Avoid loops or dips in all hose runs.

• Make sure enough hose is used to allow for future removal of components.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Brak uwag

Dometic Eskimo Ice 600 Instrukcja Naprawy Strona 11