Dometic RM2351 Instrukcja Użytkownika

INSTALLATION ANDOPERATING INSTRUCTIONSREFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATIONRM 2351USA Corporate Office CANADAService Office 2320 Industrial P

10Refrigerator control panelDESCRIPTION OF OPERATING MODESAUTO MODEWhen operating in the AUTO mode, the AUTO modeindicator lamp (A) will illuminate.Th

11HOW TO USE THE REFRIGERATORFOOD STORAGE COMPARTMENTThe food storage compartment is completely closed andunventilated, which is necessary to maintain

12MAINTENANCE & SERVICEThe user should be aware of service that must bedone on a regular schedule to keep the refrigeratoroperating properly. The

13C. Check the control system by connecting/disconnect-ing 120 volt AC power, start/stop the engine, etc.Compare the operation with the operation desc

14G. LP gas pressure low at burner.Set main regulator so pressure does not drop below11 inches of water column at pressure test port (SeeFIG. 9).H. Bu

15Put a screwdriver into the slot of the shelf lock.Turn the screwdriver counterclockwise.Remove the shelf locks from the wire shelf.Slide the wire sh

16RM 2351MO-FO 0438

3Refrigerator control panelFIG. 2ABCHECKGASAUTOONOFFAUTOMATIC REFRIGERATOR TEMPERATURE CONTROLTravel latch12LEGEND1. Main Power Button ON/OFF2. AUTO/G

4INSTALLATIONGENERAL INSTRUCTIONThis appliance is designed for storage of foods andstorage of frozen foods and making ice.This appliance is certified

5VENTILATION HEIGHTSRefer to FIG. 3a, 3b and 4.CLEARANCESMinimum clearances in inches to combustible materialsare:G: Top 0K: Side 0L: Bottom 0M: Rear

6INSTALLING REFRIGERATOR INENCLOSURENOTE: DO NOT install the appliance directly oncarpeting. Carpeting must be removed orprotected by a metal or wood

7TESTING LP GAS SAFETY SHUTOFFThe gas safety shutoff must be tested after the re-frigerator is connected to the LP gas supply.To test the gas safety s

8OPERATINGINSTRUCTIONSIMPORTANCE OF LEVELING AREFRIGERATORIn an absorption refrigerator system, ammonia is lique-fied in the finned condenser coil at

9Refrigerator control panelGAS MODE1. Move the AUTO/GAS mode selector button (2) to theUP position. The AUTO mode indicator lamp (A) willgo off. Withi